Vehicle Lift Points for Maintenance

Vehicle Lift Points for Maintenance

Any vehicle that has a frame can be lifted by the frame. When the front is lifted the jack  is usually placed under the suspension cross member. When lifting the rear the jack is  placed under the axle if it has a solid axle. If it doesn_t have a solid axle then it should  be lifted by the factory recommended lift points.  Vehicles should always be on firm, level ground. If the ground is not level then the car  may roll and tip the jack. A jack or a jack stand can also slip out or fail to hold the  vehicle in an elevated position when the ground is not firm, such as on a dirt road or  when there is ice or snow.
 
There are different types of jacks and jack stands. A jack is used to raise the vehicle  either by hydraulic pumping or hand cranking. A jack stand is used to keep the vehicle  elevated and has a firm square base. One type of jack that people are most familiar with  is the one that is included with the spare tire kit. This is to be used only for changing the  tire and it is not sufficient for keeping a vehicle elevated when working under the  vehicle. The jack used for changing tires often has a four point rectangular base. This is  not as stable as a square base.
 
When minor repairs are being performed, such as changing a tire, it is permissible to  raise just one corner of the vehicle, or the front or the rear. The vehicle is first raised  with a jack and then placed on jack stands. (Do not go under the vehicle while it is  elevated by a jack). The vehicle should be equally balanced on the jack stands.
 
A mechanic_s shop may have industry jacks or hydraulic lifts. These can be used to  raise the vehicle and keep it elevated. These lifts can raise the entire vehicle at the  same time. When lifting the entire vehicle the center of gravity should be positioned  evenly with the lifting hoist arms. This is evident when the vehicle is raised and all tires  lift off the ground at the same time. Most vehicles are front-heavy due to the engine  block. However, many work trucks are balanced to have the center of gravity in the  middle.

Comments