The Drive Train of Car (Drivetrain or Powertrain)

The Drive Train of Car (Drivetrain or Powertrain)

The drive train (drivetrain or powertrain) is a series of parts that transfer energy from the  combustion engine to the wheels. If needed, review Chapter 5 to recall how the internal  combustion engine works to convert chemical energy to rotational energy. The drive  train has three main parts: the transmission, drive line or drive shaft, and differential. In  some four-wheel drive vehicles a transfer case is also necessary.

The rotation of the crankshaft in the internal combustion engine does not equal the  rotation of the wheels. Just like a bicycle, motor vehicles have gears. The lower gears  are used for lower speeds, while the higher gears are used for higher speeds. Yet, the  RPM which is read on the dashboard tachometer may be relatively constant (or stay  within a range) through all speeds. The transmission, which is where the actual gears  are located, takes an input speed from the crankshaft and reduces it to the output speed  until the vehicle is in _direct_ drive. In other words, it changes the gear ratios. So, in first  gear you might have an input to output ratio of 4 to 1. This means that as the input shaft  goes around four times, the output shaft goes around one time. At 4,000 RPMs input  you would have 1,000 RPMs output. Second gear may have a 3 to 1 ratio and third gear  a 2 to 1 ratio. Fourth gear would be direct drive with a 1 to 1 ratio.

Think of the sprockets on a bicycle. There is a large sprocket on the front that rotates as  the bike is pedaled, and there are also large and small sprockets on the back wheel with  a chain that connects the front sprocket to the rear sprockets. As the gears are  changed, so is the mechanical advantage for the person that is pedaling reduction. 

Modern vehicles have overdrive, which is a ratio of 0.75 to 1. This means that  the input speed is less than the output speed, which results in better fuel economy on  modern vehicles. These numbers and ratios are used to present the general idea. Every vehicle has its  own input to output ratios.
 
The drive line (or drive shaft) is a round tube that transfers power from the transmission  to a differential. It is situated longitudinally underneath the car. A front-wheel drive  vehicle won_t have a drive shaft. Some four-wheel drive vehicles have more than one  drive shaft.
 
A differential (aka rear differential in rear-wheel drive vehicles, rear end, or part of the  rear axle) has hypoid gears. These are specialized gears which transmit the rotation of  the drive shaft 90 degrees in order to turn the axles and correlating wheels and tires.  There are spider gears inside the center section of the differential that allow the wheels  to travel different distances while turning. Consider a car that is turning right. The  driver_s side rear wheel travels a farther distance than the passenger side rear wheel.  Think of using a protractor to draw a circle. One leg of the protractor simply rotates on  one center spot, while the other leg draws the circle. While the rear wheels of a vehicle  don_t turn as sharply as a protractor, the principle is the same.

Comments