Cars Tire : Spec and Maintenance


Cars Tire : Spec and Maintenance
This chapter is all about tires. There may be more to these rubber doughnuts than many  people realize. In this chapter we_ll discuss tire specifications, how to check tire  pressure, wheel alignment, the wear bar, how to change a tire, and old tire disposal.
 
Tire Specifications
There are two specification sets for tires including the tire manufacturer specifications  and the vehicle manufacturer specifications. Whenever you take your car to a tire shop  to get the tires changed, they have to meet these specifications by law. You can get a  tire that goes above these specifications, but never below. The vehicle manufacturer_s specifications include speed rating, load and size. It is  located on a sticker in the driver's door jamb of the vehicle and in the vehicle owner's  manual. When buying a new tire you_ll want to stick with a tire that meets the  manufacturer's specifications because that_s the kind of tire that the vehicle was built to  use.

The tire manufacturer specifications include the tire size, load, pressure, temperature,  speed rating and tread wear. The tire manufacturer specifications indicate what the tire  is made to withstand. These specifications can be found on the wall of the tire itself.

Unless you become a tire technician, you don_t have to know all the numbers on the tire  or on the sticker/owner_s manual because every time you get your tires replaced, the  tire shop will make sure you at least have a tire that meets the required specifications. Probably the most important number for the common person to recognize is the  recommended tire pressure on the vehicle manufacturer's specifications on the driver's  door jamb sticker. (The tire manufacturer_s specifications on the tire itself include the  maximum pressure that the tire can have, yet the maximum pressure isn't necessarily  the best pressure for the vehicle).

How to Check the Tire Pressure

In order to check tire pressure you_ll need a tire pressure gauge. Gauges can be  purchased at auto parts stores and service stations (sometimes a little as $1, but could  be $3-$7). They_re usually about the size of a large pen, but can come in other forms.  Sometimes a gauge is included with the air hose of the air dispensing stand at the gas  station.

Follow these steps to check and correct the tire pressure:
  • Remove the valve cap of each tire
  • Align the gauge up to the valve 
  • Press the gauge onto the valve with firm direct pressure and then release. You_ll see the measuring stick get pushed out of the other side of the gauge (on a pen gauge). 
  • Fill the tire with air, recheck the pressure, then repeat as needed until the desired pressure is obtained.  
  • Replace the valve cap
Tire pressure is measured in PSI (pounds per square inch) or KPA (Kilopascals) which  are simply units of measurement for pressure. (Pressure is a force distributed over  surface area)

Comments